Camping and Motorhome Accessories

This is a 37 mbar regulator with 8mm copper pipe inlet and outlet.

This is a 30 mbar regulator with connector for direct attachment to a 4-hole vapour tank and an 8mm copper pipe outlet.

These tanks come with a set of 4 valves and a gas-tight box, and are designed to operate with the valves at 110 degrees down from the vertical.

This is a special version of our duo tank that allows you to run your engine from the liquid LPG outlet and your domestic facilities from the vapour outlet.

The duo tank comprises 2 (300 x 620mm) cylinder tanks that have been welded together with connecting pipes. This means that you have a combined gross capacity of 72 litres, but need only one multivalve.

This tank comes with multivalve and regulator

This vapour cylinder is designed to replace the usual exchangeable propane bottles used by campers, caravaners and motor-home users. It has the advantage that you can refill it at any LPG filling station. Other features include:
21 litre gas capacity
level guage to show how much gas is left
automatic fill stop at 80% (required for all LPG containers)
conforms to European Pi standards
easily transferred to another vehicle
can be fitted with a remote filler

This product comprises a level sender for a 4-hole tank and a level display in the form of 4 green LEDs and 1 red LED indicating reserve.

Standard UK-type filler with a straight neck. This is supplied without housing or cap. The screw thread is for a JIC filler hose.

Standard UK-type filler with a 90 degree neck. This is supplied without housing or cap. The screw thread is for a JIC filler hose.

These JIC hoses can be used to fill LPG tanks and are useful for filling large tanks (say, over 100 litres) as they reduce filling time. They screw directly onto 4-hole tanks and fillers that are not designed for 8mm copper pipe. If you want to connect to a multivalve, you will need an adaptor (sold separately).

These hoses have a straight connector at one end and a 90 degree connector at the other and come in different lengths.

These JIC hoses can be used to fill LPG tanks and are useful for filling large tanks (say, over 100 litres) as they reduce filling time. They screw directly onto 4-hole tanks and fillers that are not designed for 8mm copper pipe. If you want to connect to a multivalve, you will need an adaptor (sold separately).

These hoses have straight connectors at both ends and come in different lengths.

These clips are for the 20 mm JIC hose.
Allow 1 clip per 50 cm (max) of pipe.
Sold in packs of 5.

This T piece is for joining 3 JIC hoses, when installing 2 tanks.
It comes with 3 male ends.

This T piece is for joining 2 JIC hoses to a filler or straight joiner, when installing 2 tanks.
It comes with 2 male ends and 1 female.

This joiner is for connecting a hose to a filler or straight joiner, where a 90-degree angle is needed.
It comes with 1 male end and 1 female end.

This gate valve has quarter inch BSP inlet and outlet connectors and is used to turn off/on LPG flow.

The Acme screw-type filler is often found on American motor homes.

Some Swiss filling stations use this type too.
The adaptor has a 22mm thread.

Some Swiss filling stations use this type too.
The adaptor has a 22mm thread.