Online Catalogue

Tank Options for Kits
We stock a large range of LPG tanks of different shapes and sizes.
This section of the catalogue shows the different types, so that you know what we are talking about when we use esoteric terms.

The default tank type is the single-hole, cylinder tank of up to 90 litres.

Please note that any LPG tank can be filled to no more than 80%. So, a 90 litre tank should hold no more than 72 litres of LPG.

Have a look at the tank descriptions and decide which is best for your vehicle.

Measure (in millimetres) the space where you want to put the tank, then use the drop-down list to select the one you want.

If you can't find what you want, just select the "undecided" option, and we'll call you to discuss your order.

Sequential Gas Injection Systems
This type of system is suitable for electronically controlled, petrol-injected engines with catalytic converter, and is essential for engines with a plastic inlet manifold, and any engine manufactured in 1999 or later.

Direct injection petrol engines (such as the GDI, FSI etc.) are not suitable candidates for the current generation of SGIS. We anticipate that a new specification of SGIS will be available in 2008 to address the special requirements of direct injection petrol engines.

All Sequential Gas Injection System kits comprise:
Gas ECU and wiring looms
Gas injector rail(s), nozzles and hoses
Pressure sensor
Reducer/vapouriser
Changeover switch and level indicator
LPG filter and shut-off valve
Vapour filter
Water Ts, hose and clips
Vapour hose and clips
Plastic-coated copper pipe and clips
UK filler
Cylinder tank (up to 90 litres), cradle, straps and multivalve
Gas-tight box, vent pipe and fittings (as required)
LPG level sender
Installation Guide
Software on request

You will need a laptop PC for the simple set-up procedure, and a lead (optional extra) to connect to the SGIS.

The standard petrol injector looms come with solder connections. Plug-in type connector looms are available as an optional extra.

The cylinder tank can be upgraded to a toroidal tank.

A cylinder tank can be upgraded to a larger cylinder tank.

Single-point, closed-loop induction systems
This type of system is suitable for petrol-injected engines with catalytic converter, (providing that they have a metal inlet manifold and were manufactured before 1999).

Direct injection petrol engines are not suitable candidates for single-point induction systems.

The kit comprises:
Reducer/vapouriser
Changeover switch, wiring loom and level indicator
Petrol injector emulator and loom
Lambda control system with stepper motor
LPG filter and shut-off valve
Mixer
Water Ts, hose and clips
Vapour hose and clips
Plastic-coated copper pipe and clips
UK filler
Cylinder tank (up to 90 litres), cradle, straps and multivalve
Gas-tight box, vent pipe and fittings (as required)
LPG level sender
Installation Guide

The cylinder tank can be upgraded to a toroidal tank.

A cylinder tank can be upgraded to a larger cylinder tank.

Single-point, open-loop induction systems
This type of system is suitable for carburetted engines and early petrol-injected engines without a catalytic converter.

The kit comprises:
Reducer/vapouriser
Changeover switch, wiring loom and level indicator
Petrol injector emulator and loom (for injected engines)
LPG filter and shut-off valve
Mixer and power-valve
Water Ts, hose and clips
Vapour hose and clips
Plastic-coated copper pipe and clips
UK filler
Cylinder tank (up to 90 litres), cradle, straps and multivalve
Gas-tight box, vent pipe and fittings (as required)
LPG level sender
Installation Guide

The cylinder tank can be upgraded to a toroidal or full toroidal tank.

A cylinder tank can be upgraded to a larger cylinder tank.

Diesel Conversion Kits
This type of system is suitable for diesel engines.

Conversion of a diesel engine is different from that of a petrol engine. Diesel is always burned - you just have the option of adding LPG or not. Adding LPG helps the diesel to burn more completely. This tends to clean up emmissions and increases the power output - allowing the use of a lighter throttle and leading to fuel economy.
Care must be taken to avoid feeding in too much LPG as ADDING TOO MUCH LPG MAY DAMAGE THE ENGINE. Tinley Tech cannot be held responsible for damage caused by incorrect tuning.

The kit comprises:
Reducer/vapouriser
LPG switch, wiring loom and level indicator
LPG filter and shut-off valve
Mixer and power-valve
Vapour shut-off control system
Water Ts, hose and clips
Vapour hose and clips
Plastic-coated copper pipe and clips
UK filler
Cylinder tank (up to 40 litres), cradle, straps and multivalve
Gas-tight box, vent pipe and fittings (as required)
LPG level sender
Installation Guide

The cylinder tank can be upgraded to a toroidal or full toroidal tank.

A cylinder tank can be upgraded to a larger cylinder tank.

Trade Customers
Our regular trade customers enjoy appropriate discounts.

You can use this Online Store to see a range of our most popular items, but please remember that this site is for our retail customers and does not show our full inventory of products.

We often carry stocks of tank sizes not listed online and carry different brands of a number of the products shown online.

Please call us for further details 01954 719002.

Vehicle-Specific Kits
In this section you will find a number of frequently ordered kits for specific vehicles.

If you don't find your vehicle listed, and you can't decide what you need, just phone or e-mail us and we will find a solution for your needs.

Spares and accessories
In this section you will find replacement parts, service items and things like filler adaptors and caps.

LPG Stickers

Special Orders
This section is used to facilitate payment via SECpay for customer-specific orders that have not been selected from the on-line catalogue.